Operation And Channel Settings; Turning Off The Wireless Camera; Connecting The Monitor - Conrad 75 16 81 Bedienungsanleitung

7.4 Operation and channel settings

The channel switch (7) is at the back of the wireless camera. It is used to select the
desired transmission channel for image and sound transmission.
• If necessary, connect the wall power supply to the camera. Of course, the camera can also be operat-
ed without the wall power supply. In this case, the battery has to be completely charged (2 hours charg-
ing time).
• Select the desired camera channel by turning the channel switch (7) to position 1 (= camera channel 1),
position 2 (= camera channel 2), position 3 (= camera channel 3), or position 4 (= camera channel 4).
• When a channel has been selected, the green "Power" status LED lights up. This confirms that the
camera is now in operation.
The wall power supply may never be plugged in or unplugged with wet hands. There
is a risk of a fatal electric shock!

7.5 Turning off the wireless camera

Turn the channel switch to the OFF position to turn off the wireless camera. The red "Power" Status LED
(6) goes out.

7.6 Connecting the monitor

• Remove the battery compartment lid (20) at the back.
• Insert the provided 1400 mAh 3.7 V lithium-ion recharge-
able battery in the battery compartment (20). Watch out for
the right polarity.
• Close the battery compartment (20) by sliding the lid
back on.
• Connect the low-voltage plug of the provided wall power
supply to the "DC 5V IN" connection (12) on the monitor.
• Plug the wall power supply into a 230 V/AC 50Hz mains
socket.
25