Electrical Connection; Assembly; Appliance Installation; Adjusting The Tilting Angle - AEG IR Premium 1650 Bedienung Und Installation

9.2

Electrical connection

WARNING Electrocution
Carry out all electrical connection and installation work in accordance with relevant regulations.
» Only connect the appliance to a correctly installed mains socket.
We recommend a dedicated fuse for this appliance (see chapter "Specification / Data table"). From model 3600 W upwards,
only ever connect one appliance per fuse.
Observe the type plate. The specified voltage must match the mains voltage.
WARNING Electrocution
The appliance must be able to be separated from the power supply by an isolator that disconnects all poles with at least
3 mm contact separation.
An external socket must be able to be isolated from the power supply across all poles.
Equip the supplying power circuit of the appliance with an RCD (nominal earth leakage current d 30 mA).

10. Assembly

10.1 Appliance installation

Check in chapter "Specification / Data table" whether you are able to install the appliance vertically or horizontally.
» Secure the mounting bracket on the wall or ceiling using suitable fixing materials.
» Secure the appliance to the mounting bracket using the screw and nut provided.
» Route the power cable from the appliance either towards the back, top or bottom.

10.2 Adjusting the tilting angle

The tilting angle can be adjusted over a range of 100°. We recommend a setting of 45°.
CAUTION Burns
If the appliance is already in use, let it cool down before adjusting the tilting angle.
» Undo both screws on the pivot hinge.
» Set an appropriate tilting angle.
» Retighten the two screws again.
Ensure that the appliance does not come into contact with the power cable.

10.3 Dismantling

Pull the mains plug out of the socket.
CAUTION Burns
First allow the appliance to cool down before transporting or storing it.
Remove the appliance from the wall mounting bracket.

11. Handover

Explain the functions of the appliance to the user. Draw special attention to the safety information. Hand the operating and
installation instructions to the user.

12. Troubleshooting

Only use an original spare part from us if you are replacing the power cable.
Installation - for contractors
17