Inhaltsverzeichnis
Werbung
Contents
Safety instructions
For your protection
• Read the operating instructions in full before starting up and
follow the safety instructions.
• Keep the operating instructions in a place where they can be
16
accessed by everyone.
EN
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health
Page
and safety and accident prevention regulations.
• Wear your personal protective equipment in accordance with the
2
hazard category of the media to be processed.
2
• Caution! The supply voltage (Limited Power Supply) for the
16
ETS-D6 must be provided using an IEC 61558 compliant trans-
17
former with double or reinforced insulation. Alternatively, labora-
18
tory equipment that meets the requirements of IEC 61010 or
18
NEC Class 2 may be used.
18
• Caution! This equipment must only be used with media that
18
have a flash point higher than the temperature safety limit set for
19
the magnet agitator and/or heating system used.
19
The safe temperature limit must always be set to at least 25 °C
19
lower than the fire point of the media used.
19
• Burn hazard! Take care when touching the temperature sensor!
20
The temperature sensor may heat up to 450 °C when inserted in
20
the media!
20
• Do not touch the temperature sensor while measurements are
20
being taken. This will prevent incorrect results.
21
• Ensure that the external temperature sensor (PT 1000, ETS-D ...)
21
is inserted in the media to a depth of at least 20 mm, see fig. 2.
21
• Please ensure that the spiral cable does not come into contact
22
with the heating plate.
22
• The stainless steel temperature sensor must not be used with
23
aggressive media such as acids, caustic solutions or distilled
24
water, due to the risk of corrosion. The glass sensor should be
24
used in such cases.
• Only use glass encapsulated temperature sensors for electrolysis
procedures.
• Always use the extension cable H 70 when the media being proces-
sed produces vapour. This ensures that the control unit does not
come into contact with the vapour.
• Beware of hazards due to:
- flammable materials
- combustible media with a low boiling temperature
012007
Werbung
Kapitel
Inhaltsverzeichnis
