Barring Outgoing Calls; Direct Call; To Program The Direct Call Number; Turn The Direct Call Function On/Off - Topcom butler 2455 Bedienungsanleitung

HANDL. B2455_euro.qxd
Butler 2455
Notes :
•
Before you can select a base unit, the base unit must be subscribed to the handset first.
•
If 'NOT SUB' appears on the display, this means the selected base unit does not exist or the handset has
not been subscribed.

4.29 Barring outgoing calls

You can program the handsets to bar calls to certain telephone numbers so that for instance '00'
international numbers cannot be called. Up to 5 numbers (of max. 5 digits) can be barred.
To do this, do the following:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'PIN' appears on the display.
• Enter your PIN code
• Press the Programming key
• 'BAR NUM ' appears on the display. You are in memory "1. _ _ _ _ _".
• Press the Up or Down key
• Enter the number (max. 5 digits) to be barred, e.g. 01486.
• Press the Programming key
• 'HS _ _ _ _ _' (= number on the handset (1-5)) '01486' (= the barred numbers) appear on
the display.
• Enter the numbers of the handsets from which the barred numbers cannot be called.
• e.g. Press the number key 2, 3 and 5. On the display, this will appear: HS _2 3_5 01486
These handsets can no longer dial numbers beginning with '01486'.
• Press the Programming key
Repeat the same procedure described above if you would like to bar other numbers (max. 5)!

4.30 Direct Call

By setting a Direct Call number, the phone will automatically take the line and dial out this
number. This function is useful to use the phone as a emergency phone.

4.30.1 To program the Direct Call number

• Press the Programming key
• Press the up or down key until 'DIRECT' appears on the display
• Press the Programming key
• If necessary, delete the existing number by pressing the Delete-key a few times
• Enter the direct number
• Press the Programming key

4.30.2 Turn the Direct Call function ON/OFF

To turn it ON:
• Press the Programming key
• Press the up or down key until 'DIRECT' appears on the display
27/2/03 9:01 pm
.
repeatedly until 'SETTING' appears on the display.
.
repeatedly until 'BARRING' appears on the display.
.
.
to select one of the 5 memories.
.
to confirm your selection.
23 23 23 23 23 23 23 23 23 23 23 23 23
Page 23