Before Getting Started; Inserting The Batteries - Auriol AUB 2 A1 Bedienungsanleitung

Watch winder AUB 2 A1

Before Getting Started

Remove the watch winder and all accessories from the packaging and check that all items have
been included. Remove the protective foil from the viewing window of the watch winder. Connect
the small plug of the power supply adapter (G) to the power supply jack (10) at the rear of the
watch winder. Insert the power supply adapter (G) into a mains socket that is easily accessible. The
watch winder is now ready to use.

Inserting the batteries

If you would like to use the watch winder with batteries, proceed as follows:
Batteries are not supplied. 2 x 1.5V
type AA / LR6 batteries are required.
Press down the tab on the cover of the
battery compartment and remove it.
Ensure correct polarity of the batteries.
The correct polarity is illustrated in the
battery compartment (7) and on the
batteries. Close the battery
compartment (7) again by first inserting
the two guide tabs of the battery
compartment cover into the slots below
in the battery compartment (7) and by
then pushing the cover upwards until
you hear it lock into place. The watch
winder is now ready to use.
26 - English