Additional Functions - Bosch SGS59A03 Gebrauchsanweisung

Intensive drying function
Activating the intensive drying function
increases the temperature during the
rinse-aid stage which gives better drying
results.
Press and hold the A programme
button, and set the main switch
ON.
Release both buttons.
Either (ON) or
the numerical display
Press the A programme button to
change the setting.
Set the main switch
new setting is stored in the dishwasher
memory.
Cancel programme (Reset)
Only when the master switch is ON.
Press the A and C buttons
simultaneously, and hold them pressed
for approx. 3 seconds.
The numerical display shows
Close the door.
The programme continues for approx.
1 min.
When it has ended, set the main switch
to OFF.
1
Close the detergent compartment
To restart the dishwasher, set main switch
to ON again and select desired
1
programme.
Changing the programme
It is possible to change the programme
within 2 minutes after you have switched
the dishwasher on.
Should it be necessary to change the
programme after this period, the
programme cycle that has already been
begun (e.g. washing) will be completed
first of all.
The new remaining time displayed is the
sum of the remaining time from the
preceding programme cycle and the
remaining time attributable to the new
programme that has been selected.
to
1
(OFF) flashes in
.
4
to OFF. The
1
.
.
30

Additional functions *

*
on applicable models
Pre-Soak *
The Pre-Soak programme option serves to
perform a pre-soak cycle before the main
programme. This cycle enables cookware,
e.g. pans, bowls, etc. to be pre-soaked
and pre-rinsed in the lower rack. If you
wish to pre-soak the dishes, this
programme option must be selected by
pressing the "Pre-Soak" button before the
programme starts. The recommended
detergent amount is approx. 5 g poured
onto the inside of the door.
Quick *
Pressing the "Quick" button provides a
short wash cycle by curtailing the drying
phase and the washing time. The washing
and drying performance will be reduced
with the Quick programme option.
Washing contents of UPPER
RACK only *
If you have a small number of dishes to
wash in the upper rack (e.g. glasses, cups,
plates), switch on the UPPER RACK
function. If you select the UPPER RACK
function, the lower rack must be empty.
Add a reduced amount of detergent
compared to that which is recommended
for a full load.
Washing contents of
LOWER RACK only *
If you have a small number of dishes to
wash in the lower rack (e.g. plates, pans,
bowls), switch on the LOWER RACK
function. If you select the LOWER RACK
function, the upper rack must be empty.
Add a reduced amount of detergent
compared to that which is recommended
for a full load.
en
39