Auto Shut-Off - Bosch TDS25 Serie Gebrauchsanleitung

Vertical steam (C)
1. Set the temperature control to the "•••" or "max"
position.
2. You can steam iron curtains and hanging garments
(jackets, suits, coats...) by placing the iron in a vertical
position and pressing the steam release button (14).
Never direct the steam jet at garments that are being
worn.
Never aim the steam at people or animals.
Stain remover steam gun
(depending on the model)
Preparation:
Ensure that the appliance is not connected to the mains.
Remove connection plug for the iron (21) if this is connected.
Then lift the cover (22) and insert the connection plug for
the steam gun in the correct position - with slot to the left
- Then follow the same steps as for ironing, the indicator
lights and switches operate in exactly the same way.
Important:
When the gun is being used, while pushing steam release
button (17), there might be some water drops, but this is
normal.
Attention
• Use the steam gun in intervals of no longer than 10
seconds at a time.
• Direct the first steam jets towards a cloth in order to
eliminate any possible water condensation residue from
the steam tube.
• Never direct the steam jet at garments that are being
worn by people or animals.
• Do not use the brush extension for delicate fabrics such
as silk or cashmere.
To refresh fabrics
Refreshing garments with the steam gun can lessen
creases and wrinkles, although this does not substitute
ironing with the iron.
For better results, hang the clothes which you would like to
refresh on hangers.
With diffuser (20) the sprayed steam enables superficial
fabric creases to be lessened.
Fully insert the accesory into the concentrator (18). Press
the steam release button (17) for the steam supply and
direct the jet towards the fabric that you would like to
refresh. Maintain a minimum distance of 10 cm to avoid
getting the fabric too damp.
To remove fabric stains
The steam gun can help to remove washable, fresh stains.
The concentrator (18) and brush extension (19) supply a
concentrated jet of steam that makes it possible to remove
certain types of fabric stains
• If the stain is not fresh, the garment should be washed
in a washing machine or hand-washed according to the
garment care label.
• For stubborn or non-washable stains, take the garment to a
specialist cleaning centre or dry cleaners.
Use the concentrator (18) to direct the steam jet at the
stain, in direction from the outer side of the garment into the
fabric placing a sponge or cloth underneath it to absorb the
dirt. The brush extension (19) can also be used with gentle
action to support the cleaning effect.
Intelligent steam
(depending on model)
This system has intelligent steam control, which, after
releasing the steam release button (14), provides a small
amount of additional steam.
The additional steam can always be stopped by briefly
pressing the steam release button once again.

Auto shut-off

(depending on the model)
If during ironing the steam release button (14) on the handle
of the iron is not pressed for a certain length of time (8
minutes), the steam station will automatically switch off.
The "Auto shut-off" pilot lamp (6) will flash when auto shut-
off has been activated.
To switch the steam station back on, press the steam
release button again, and wait until the "Auto shut-off" pilot
lamp remains lit continuously.
Cleaning & Maintenance
Always unplug the appliance from the mains supply
before carrying out any cleaning or maintenance
operation on it.
1. After ironing, pull out the plug and allow the appliance to
cool down before cleaning.
2. Wipe the housing, handle and iron body with a damp
cloth.
3. If the soleplate is soiled with dirt or scale, clean it with a
damp cloth.
4. Never use abrasive products or solvents.
Storing the appliance (D)
1. Always allow the applianc,5
Fabric protection soleplate
cover (E)
(depending on the model)
The fabric-protection soleplate cover is used for steam-
ironing delicate garments at maximum temperature without
damaging them. Use of the soleplate cover also does
away with the need for a cloth to prevent shine on dark
materials.
It is advisable to first iron a small section on the inside of the
garment to see if it is suitable.
To attach the soleplate cover to the iron, place the tip of
the iron into the end of the soleplate cover and pull the
elastic strap over the lower rear of the iron until it fits tightly.
To release the soleplate cover, pull the elastic strap and
remove the iron.
en
13