Installation - Omnitronic AR-212A Bedienungsanleitung

1
Cooling fins
2
LED LIMIT
Lights up when the level limitation is active.
3
Power indicator
4
LED PROTECT
Lights up if the protective circuit responds:
• shortly after switching on and off
• in case of overheating or defect of a power
amplifier
5
Microphone input
Balanced combo input (XLR/6.3 mm jack) for
connecting a microphone.
6
Line input
Balanced combo input (XLR/6.3 mm jack) for
connecting audio units with line level output (e.g.
mixers or CD players).
7
Feed-through output LINK
Balanced XLR output, connected in parallel to the
line input, to connect a further active speaker
system.

6. INSTALLATION

The speaker system can be set up as desired. The location must be solid, plane, anti-slip, vibration-free,
oscillation-free, and fire-resistant. The installation area must hold a minimum point load of 5 times the
system's load (e.g. weight 20 kg - point load 100 kg). The speaker system must never be installed higher
than 100 cm without secondary attachment.
The speaker system features two transportation handles. It should be carried without force by two persons of
the same size. Carrying the speaker system by one person should be avoided as the high weight and the
strain could lead to back damages and torsions. Please note that all speaker systems with more than 25 kg
weight must be transported with two persons.
Installing and orienting the speaker system
When installing the speaker system on e.g. a stage, microphones and turntables should always be located
behind the speaker systems. In this way, you can avoid dangerous and unpleasant feedback. If you cannot
install the speaker systems this way, the microphones and turntables should be located as far away as
possible from the speaker systems. When using the speaker system as monitor system make sure to avoid
feedback.
The speaker systems of a PA system are normally located left and right to the stage. Do not install the
speaker systems on the stage, but rather on appropriate tables or platforms in front of the stage.
In order to produce a clear sound, the speaker systems should be installed in a way that they throw the
sound over the audience's heads. A full-range speaker system should be installed at listeners' eye level.
Please refer to the safety instructions under Installation.
Loudspeaker combinations need to be installed bass-middle-high (from bottom to top). Make sure that the
membranes of all speakers are in one line vertically and horizontally. Only in this way all frequency ranges
are produced at the same time and without any time or phase delays.
Always install the speaker systems in a way that a minimum distance of three meters to the audience is kept.
This is the only way to avoid hearing damage for unreasonable listeners. Block the area in front of the
speaker systems with appropriate means.
8
Level control the overall volume
9
Level control the microphone input
10
Level control the line input
11
Tone controls
2-way tone control for the mixed signal: HIGH =
high frequencies, LOW = low frequencies.
12
Voltage selector switch
13
Power switch
Turns power to the speaker system on and off.
14
Fuse
Only replace the fuse when the device is
disconnected from mains. Only use fuses of the
same rating and power. The correct fuse value is
specified on the rear panel.
15
Power input
Plug in the supplied power cable here.
19/23 00074291.DOC, Version 1.0