Installation - Brita PURITY Quell GY Handbuch

• A non-return valve according to DIN EN 13959 tested by the DVGW has been factory installed
at the water intake of the fi lter head.
• No copper pipes and no galvanised or nickel-plated pipes/connectors may be installed between
the water fi lter and the consumer. The use of BRITA hose sets is recommended here. When
choosing the material for parts that come into contact with water after the BRITA fi lter system
it must be remembered that, due to the process, decarbonised water contains free carbon diox-
ide.
• All parts must be installed in accordance with the country-specifi c guidelines on the installation
of drinking water facilities.
• For erection and operation of the fi lter system, the BG rules "Working in Kitchens" of the Spe-
cialist Committee "Foods" of the BGZ (BGR111) must be observed.

4 Installation

Caution: Prior to installation, read the Technical Data (Chapter 12) and the Operating and Safety
!
Information (Chapter 3). After the product has been stored and transported at temperatures below
0°C, it must be stored with the original packaging open for at least 24 hours before commissioning.
4.1 Delivery Scope
For installation of a PURITY Quell ST new fi lter, you need the packaging units pressure vessel
(incl. fi lter cartridge) and pressure vessel lid
Prior to installation, remove the entire delivery scope from the packaging and check that everything
is present:
1 x Pressure Vessel
1
1 x Pressure Vessel Lid
1 x Filter Cartridge
2
1 x Manual
1 x Carbonate Hardness Test
If part(s) of the delivery scope are missing, please contact your local BRITA Offi ce.
4.2 Assembling the Pressure Vessel and the Pressure Vessel Lid
•
•
•
•
•
•
4.3 Assembly of Inlet and Outlet Hoses
Note: The inlet and outlet hoses are not included in the standard scope of delivery. The use of
BRITA hose sets is recommended (Chapter 13).
• Fit inlet hose at the inlet of the connector head
6
nector head .
4
Note: Inlet "IN" and outlet "OUT" of the connector head
seals, therefore no additional fl at seals may be used here. Check that the O-rings are seated
correctly.
Caution: The max. tightening torque at the 1" and 3/4" connections must not exceed 15 Nm!
!
Only hose connections with fl at seals may be used. Hoses with conical screwed connections dam-
3
3
Stand with both feet on the kick loops
Lift the pressure vessel
are over the kick loops
Remove the transport protective cap
Check that the O-ring seal of the fi lter cartridge
groove and also check for dirt and damage.
Note: lubricant at the factory.
Stand on the kick loops
on the pressure vessel
handle must match the "INSERT" groove.
20
Press the pressure vessel lid
engages.
.
.
12
and turn it clockwise until the mantle handles
1
.
12
from the fi lter cartridge.
18
with both feet and place the pressure vessel lid
12
. The position of the arrow marking on the lid
1
down and turn clockwise until the lock
3
and outlet hose
4
are equipped with O-rings as
4
is correctly seated in the
2
at the outlet of the con-
10
1
16
3
15
25