Mains Connection; Starting Operation - Jet JTSS-1700 Gebrauchsanleitung

5.4 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
16A surge-proof fuse.
Only use connection cables marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
The machine is equipped with a
16Amp CCE Euro plug, mounted at
the back side of the frame.
Attention:
-Check first if the saw spindle runs
freely and if all safety devices are
fitted before starting the machine.
- If the direction of rotation is not
correct, the phase converter inside the
CCE Euro plug must be pushed in and
turned 180°.
(Clockwise direction of the spindle is
correct).
For safety reasons this must only be
done without the sawblade installed!

5.5 Starting operation

You can start the machine with the
green On-button. The red Off-button
stops the machine.
The scoring sawblade is started and
stopped simultaneously with the main
sawblade.
Note:
-When the lower sawblade cover is
open, it is impossible to start up the
machine.
-In case of machine overload the
motor overload cut-off will react.
After appr.10 min of cooling the
machine can be started again.
6. Machine operation
Correct working position:
In front of the machine standing out of
the line of cutting (danger zone).
Fig 11
Workpiece handling:
Hands placed flat on the workpiece
outside the cutting area.
Feed the workpiece towards the saw
blade in the direction of the saw line.
Push the workpiece steadily forward;
complete the cut as a single
movement.
Support long and wide workpieces
with helping roller stands.
The use of a power feeder is not
considered.
Crosscut with crosscut fence
Fig 12
6
Trimming with back stop
Fig 13
Operating hints:
Work only with a sharp and flawless
sawblade.
Take care that the selection of the saw
blade depends on the material to be
cut.
Use a suitable wedge to prevent round
timber from turning under the
pressure of the cut.
Use suitable table extensions and
supporting aids for difficult to handle
workpieces.
Always hold and guide the workpieces
safely during machining.
Do not perform any operation
freehand.
Take care when slotting.
When ripping narrow workpieces
(<120mm) use as push-stick or push-
wood.
Make sure that small cut off
workpieces will not be caught and
thrown away by the rising saw blade
teeth.
Remove cut and jammed workpieces
only when motor is turned off and the
machine is at a complete standstill.
Pay particular attention on reducing
the risk of kickback.
The supplied raving knive must
always be used.
For the authorized use of the
machine observe the appendix A
"safe operation"
(on the last pages of this operating
manual)
A.1.: Ripping
A.2.: Ripping of narrow stock
A.3.: Crosscutting on rip fence