Installing The Heater Sensor F1 With Excess Temperature Fuse - Sentiotec Pro B3 Montage- Und Gebrauchsanweisung

Installation instructions, only for experts
4.2.

Installing the heater sensor F1 with excess temperature fuse

Observe the following points when installing the heater sensor:
● The heater sensor must be installed on the rear of the heater, above the mid-
dle of the sauna heater. An interval of approx. 15 cm to the roof of the sauna
room must be maintained.
● The heater sensor must be attached in a way that it is not affected by a l ow
of air.
To install the heater sensor, perform the following steps (see Fig. 3):
1. Lay the two 2-pin heater sensor wires in the wall of the sauna room, leading
them to the heater sensor installation location and afi x the heater sensor
wires using wire clips.
2. Pull the two half-shells
3. Connect the four connectors for the heater sensor wire
with the Fig. 3.
4. Place the connection panel
sensor half-shells.
5. Place the two half-shells together, screw them together using the two Phillips-
head screws
securely closed.
6. Install the heater sensor on the rear of the heater using the two wood screws
6
enclosed
WORLD OF WELLNESS
1
of the heater sensor apart.
2
crossways (as shown in Fig. 3) in the heater
3
(9 mm) and check whether the heater sensor has been
(16 mm).
5
in accordance
1
Heater sensor half-shells
2
Connection panel
3
Phillips-head screws (9 mm)
4
Heater sensor
5
Heater sensor wires
6
Wood screws (16 mm)
Fig. 3 Installing the heater
sensor
p. 15/38
EN