Maintenance Products; Intenza+ Water Filter; Intenza+ Installation; Intenza+ Replacement - Gaggia ANIMA PRESTIGE Bedienungsanleitung

Vorschau ausblenden

Inhaltsverzeichnis

Verfügbare Sprachen

10.2 INTENZA+ water filter

10.2.1 INTENZA+ installation

OFF

10.2.2 INTENZA+ replacement

Product

• Descaling solution

• INTENZA+ water filter cartridge

• Brew group grease

• Degreasing tablets

• Milk circuit cleaning system

• Maintenance kit

It is recommended to install the INTENZA+ water filter that limits limescale formation

inside the machine and improves the aroma of your coffee.

Water is a fundamental component of coffee brewing: this is why it is essential to filter

it professionally. The INTENZA+ water filter can prevent the formation of mineral

deposits and improve water quality. It is sold separately.

Remove the small white filter in the water tank and store it in a dry place.

Filter setting phase

Remove the INTENZA+ water filter from its packaging, immerse it vertically in cold

water, with the opening upwards, and slightly press the sides to let air bubbles out.

In order to use the filter correctly, it is necessary to measure the water hardness as

shown in the "5.3.1 Water hardness measurement and setting" chapter.

Set the INTENZA+ water filter according to the results of the test, operating on the

filter base:

Letter on the filter

Insert the INTENZA+ water filter in the empty water tank.

Push it to the lowest possible point.

Fill the water tank with fresh water and restore it to the machine.

Dispense all the water contained in the tank as detailed in the "6.5.1 Hot water

dispensing" chapter.

Fill the water tank again.

Machine setting phase during the installation

Press the MENU button, confirm by pressing the OK button and scroll the menu to go

to the 'INTENZA+ Filter function. ' The default setting is OFF (inactive filter).

Press the UP button to select the ON value.

Press the OK button to confirm the change.

The modified but unconfirmed values will not be stored.

With the ON value the machine is programmed to inform the user that the

INTENZA+ water filter must be replaced.

Once the INTENZA+ filter has been activated, no icon appears on the

display.

Press the ESC button to exit the programming function.

The machine automatically exits the programming mode if no button is pressed for 3

minutes. At the end, the machine goes back to the main menu.

The 'INTENZA+ water filter to be replaced' signal is displayed.

Replace the INTENZA+ water filter as described in the "10.2.1 INTENZA+

installation" chapter, performing only the "Filter setting phase" section, and then

proceed as follows.