Gaggia ANIMA PRESTIGE Bedienungsanleitung Seite 24

START
CALC
CLEAN
CALC
CLEAN
CALC
CLEAN
CALC CLEAN
18
ENGLISH
Do not remove the brew group during the descaling process.
Do not drink the descaling solution or the products resulting from the descaling cycle.
Use exclusively the Gaggia descaling solution. The use of other products may damage
the machine and leave residue in the water. The Gaggia descaling solution is sold
separately. For further details please refer to the "10.1 Maintenance products" chapter.
Preparation phase
Press the side buttons.
>
>
Remove the drip tray.
>
Remove the coffee grounds drawer and empty it.
>
Empty and wash the drip tray.
>
Restore all the components.
>
Fill the milk carafe following the instructions of the "6.2 Milk carafe" chapter until "Start
up phase" is done, taking into account that the carafe should be filled with water, not
milk, to the MIN level.
>
Place a large container (1.5 l) under the dispensing spout.
Descaling phase
If the INTENZA+ water filter is present, extract the filter from the water tank and
replace it with the original small white filter.
>
Pour all the descaling solution in the water tank.
>
Then fill the tank with fresh water to the CALC CLEAN level.
>
Put the water tank back in the machine.
Press the MENU button, confirm by pressing the OK button and scroll the menu to
>
go to the descaling function.
>
Press the OK button to select the descaling function.
The machine displays the necessary sequence of operations: carafe insertion, milk
frother dispensing spout extraction.
>
Press the OK button to launch the descaling cycle. The machine starts dispensing the
descaling solution at intervals. The bar shows the cycle progress status.
The cycle can be paused by pressing the ESC button and restarted by pressing the OK
button. This makes it possible for the user to empty the container or leave for a while.
Let the water be discharged until the tank is empty.
>
Remove the water tank and rinse it.
>
Fill it with fresh water to the MAX level and return it to its proper place.
>
Remove and empty the container.
>
Remove the milk carafe as shown in the "6.2 Milk carafe" chapter, "Removing phase"
and empty it.
Repeat the entire sequence of operations described in the "Preparation phase" above
and proceed with the "Rinsing phase".
Rinsing phase
Press the OK button to launch the rinse cycle.
>
The cycle can be paused by pressing the ESC button and restarted by pressing the OK
button. This makes it possible for the user to empty the container or leave for a while.
If the water tank was not filled to the MAX level, the machine might require another
rinse cycle. In this case, fill the water tank to the MAX level, put it back in the machine
and repeat the "Rinsing phase".
Let the product be dispensed until the process stops automatically.
>
Press the OK button to exit the descaling cycle. The machine goes through the heating
and automatic rinse process.
>
Remove and empty the container with dispensed water.
Perform the "7.4.3 Weekly cleaning of the milk carafe components" procedure.
Perform the "7.2.1 Weekly brew group cleaning cycle" procedure.