Operation - DeWalt D51430 Originalanweisungen

E N G L I S H
Removing the trigger
• Disconnect the airline from the tool.
• Remove all fasteners from the magazine.
• Remove the rubber grommet (8) from the end of
the dowel pin (9).
• Remove the dowel pin.
• Remove the trigger assembly (10).
Fitting the trigger
• Insert the trigger assembly into the trigger cavity,
ensuring that the trigger spring (11) is properly
seated.
• Insert the dowel pin (9) through the tool frame,
contact trip guide and trigger assembly.
• Push the rubber grommet (8) onto the end of the
dowel pin.
Air fi tting (fi g. A)
These tools have a standard 3/8" pipe thread for the
air fi tting (7).
• Wrap the male end of the fi tting with Tefl on tape
to prevent air leaks.
• Screw the fi tting into the end cap and tighten fi rmly.
Loading the tool (fi g. C)
• Lock the magazine latch (6) in the back position.
• Select an appropriate collated fastener stick.
See "Technical data".
• Place the collated fastener stick(s) onto the
magazine rail (11).
• Release the magazine latch by unlatching the
lever (6).
• Carefully slide the latch forward to press against
the fasteners.
Unloading the tool (fi g. C)
• Lock the magazine latch (6) in the back position.
• Remove the collated fastener stick(s) from the
magazine rail (11).
WARNING: Always disconnect the tool
from the air supply before loading or
unloading fasteners.
Adjusting the driving depth (fi g. D)
The driving depth can be adjusted to the type of
fastener used.
22
WARNING: To reduce risk of serious injury
from accidental actuation when attempting
to adjust depth, ALWAYS:
• Lock OFF trigger.
• Disconnect air supply.
• Avoid contact with trigger during
adjustments.
• To reduce the depth, rotate the depth setting
wheel (3) to the right.
• To increase the depth, rotate the depth setting
wheel (3) to the left.
Trigger lock (fi g. A)
This tool is equipped with a trigger lock-off switch
which prevents the tool from fi ring a fastener.
• To engage the trigger lock, push the switch (2) to
the right.
• To release the trigger lock, push the switch to the
center.

OPERATION

Instructions for use
WARNING: Always observe the safety
instructions and applicable regulations.
Proper Hand Position (fi g. F)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper
hand position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the main
handle (15).
Preparing the tool (fi g. A)
• Drain all condensation from the air compressor
tanks and hoses.
• Lubricate the tool. See "Maintenance".
• Remove all fasteners from the magazine.
• Check if the contact trip (4) can move freely.
WARNING: Do not use the tool if the
contact trip cannot move freely.
• Check that the pressure of the air supply is below
the maximum recommended operating pressure.
• Connect the air hose to the fi tting on the tool.