Cleaning And Servicing; Troubleshooting - Olympia A 2020 Anleitung

Cleaning and Servicing

Deposits and residual adhesive on the transport rollers can influence the re-
sults of the laminating process. Therefore, the transport rollers must be
cleaned periodically after use:
To do this, insert a folded piece of paper in the insertion slot. Residual adhe-
sive is removed and taken up by the paper when ejected. Repeat the proc-
ess several times.
Disconnect the power plug before starting to clean the unit with a damp cloth.
If necessary, the housing can be cleaned using a cloth moistened with clean
water with a little mild soap applied. Never use any solvents or aggressive
cleaning agents.

Troubleshooting

Fault
 Red LED (POWER) does not light
up
 Unit does not respond
 Foil jam
 Laminated foil is not completely
transparent
Corrective measures
 Check that the power plug has
been properly connected to the
power socket.
 If the fault cannot be cleared, con-
tact our hotline.
 Check the foil pockets being used
are the correct size.
 Only use pouches of the size speci-
fied.
 Ensure that the pouch has been in-
serted correctly in the unit.
 To clear the fault, follow the instruc-
tions in the Section "Clearing Foil
Jams".
 Laminate the same foil again to im-
prove the lamination result.
Conformity of the equipment to the
EU directives is confirmed by the
CE symbol.
16