Features; Hot Laminating - Olympia A 325 Bedienungsanleitung

Features

Protection and refinement of your documents.
Laminate photographs, documents, graphics, identity cards etc. up to A3
size. The unit operates using 2 heating rollers, has a quick warm-up phase
and laminates without a carrier.
•
2 LED lamps indicate the operating states "Cold laminating ready"
and "Hot laminating ready"
•
Automatic switch-off in the event of overheating
•
High quality heating system prevents smudging and blistering
•
Warm-up phase only about 3 – 5 minutes
•
Cool down phase to room temperature, approx. 30 minutes
• Foil thickness, minimum 75 μm and maximum 125 μm
Laminating system:
Working width:
Laminating temperature (COLD),
(HOT)
Maximum laminating width:
Warm up period:
Maximum foil thickness:
Laminating speed:
Power supply:
Current consumption:
Power consumption:
Dimensions (LxWxH):
Weight:

Hot Laminating

1 Connect the power cable to an easily accessible, standard electrical
socket.
Caution: Check that the voltage specifications of the unit correspond
to that of your power supply network (220 – 240 V, 50 Hz).
2 Switch on the On/Off switch on the top, right-hand side of the unit:
HOT
3 The drive motor for the transport rollers starts up. The warm-up phase
begins. The correct operating temperature is reached after about
3 – 5 minutes and the red indicator lamp lights up.
Hot roller technology
332 mm (A3)
35 °C,
97 – 105 °C
332 mm
3 – 5 minutes
75 – 125 micron
300 mm/min
220 – 240 Volt, 50 Hz
1 A
200 VA
466 x 108 x 76.50 mm
Approx. 1400 g
16