Long-Term Storage - Load Up 75051 Gebrauchsanleitung

8.5 Tighten cylinder head bolt
Tightening the cylinder head bolt requires a special tool.
Do not try yourself. Contact with our agents.
8.6 Check the injection nozzle and fuel injection pump
1. Adjust the clearance of the intake/exhaust valves.
2. Grind the intake/exhaust valves.
3. Replace the piston'ring.
All these operation require special tools and skills, contact with your our agents.
Warning:
• Do not perform the injection nozzle test near an open fire or any other kind of
fire. The fuel spray may ignite. Do not expose bare skin to the fuel spray. The
fuel may penetrate the skin and cause injury to the body. Always keep your body
away from the nozzle.
8.7 Check and refill the battery electrolyte and charge the battery
The diesel uses a 12 V battery. Battery electrolyte will be lost through
continuous charging and discharging.
Before starting, check for physical damage to the
battery and also the electrolyte levels and refill the
distelled water till to the upper level if neccesary.
When actual damage is discovered, replace the
battery.
Check the battery electrolyte monthly.
Warning:
• The battery electrolyte contains sulfuric acid. Protect your eyes, skin
and clothing. In case of contact, flush thoroughly with water and get
prompt medical attention, especially if your eyes are affected.
• The battery exhaust hydrogen gas, which can be highly explosive. Do
not smoke or allow flames or sparks near the battery, especially during
charging.
8.8 Check the generating set carbon brush and slip ring.
Often check the generating set carbon brush and slip ring. Readjust if there is
spark.
9. LONG TIME STORAGE
If store the generating set for long periods, make the
following preparations
1 Operate the engine for about 3 minutes and then
stop.
2 Stop the engine. Drain the engine oil while the
engine is still warm and fill with fresh oil.
39