Faults And How To Remedy; Guarantee Terms - Wolf Garten 2.40 BC Gebrauchsanweisung

Maintenance
Sharpening and changing blade (fig. W3)
Blade should always be sharpened by an approved Service Centre. Change blade according to drawing.
Gloves should be worn at all times when working on the blade. Remove ignition key and spark plug lead when working on
the blade. Information for Service Centre, blade retaining screw to be tightened to: screw = 38-42 Nm.
Winter storage
• Drain fuel tank.
• Drain carburettor
- therefore start engine, keep it runninug until it automaticalli switches off.
• Clean the whole machine thoroughly
• Change oil, 4-stroke engine.
• Prepare engine for winter storage as follows:
- Remove spark plug
- Poor one spoon full of engine oil into spark plug hole
- Pull starter rope slowly to distribute oil evenly inside cylinder
- Replace spark plug but do not connect spark plug lead
- Pull starter rope until resistance is felt (valves are now closed)
• Store mower in a cool and dry place.
We recommend: Have your mower thoroughly checked once a year by approved Service gent.

Faults and how to remedy

Problem
Motor does not start or
has no power:
Uneven cutting:
When in doubt, always consult a WOLF service workshop. Important: switch off the mower and disconnect the spark
plug lead before inspecting, cleaning or working on the blades.

Guarantee terms

Please carefully retain the guarantee card completed by the seller, or the proof of purchase.
The company WOLF-Garten provides a guarantee for 24 months from the date of purchase. This guarantee is in accordance with the
relevant state of technology and the utilisation purpose / area of application. The consumer's statutory rights are not affected by the following
guarantee guidelines.
Pre-conditions for the 24-month guarantee entitlement:
- Deployment of the device solely for private use.
The guarantee is reduced to 12 months in the commercial sector or leasing business.
- Proper handling and observance of all information given in the operating manual, which forms part of our guarantee terms.
- Observance of the prescribed maintenance intervals.
- No unauthorised alteration of the design.
- Installation of original WOLF replacement parts / accessories.
- Presentation of the completed guarantee card and/or proof of purchase.
This guarantee does not extend to normal wear-and-tear on blades, blade mounting components or friction disks, V-belts/toothed belts, running
wheels/tyres, air filters, spark plugs and spark plug connectors. ny guarantee claim shall be immediately void in the event of unauthorised
repairs. Faults and defects which can be traced to material or manufacturing faults will be rectified exclusively by our contracted workshops
(the seller has the right to remedy a defect) in your vicinity, or by the manufacturer if the latter is closer. ny claims going beyond the provision
of a guarantee are ruled out. There is no entitlement to a replacement. ny transport damage should be reported not to us but to the shipper
in question since, otherwise, any compensation claims vis-à-vis the shipper would be voided.
Possible cause
• Insufficient fuel in the tank
• Spark plug lead not connected
• Spark plug out of order
• ir filter dirty or oily
• Blade fastening screw loose
• Clutch linings worn
• Cutting height misadjusted
• Blunt blades
• ir / duct catcher bag blocked
WOLF
service
workshop
---
---
---
---
X
X
---
X
---
11
Remedy (X) by:
Yourself
X
X
X
X
---
---
X
---
X