Wolf Garten Campus 400 B Gebrauchsanweisung Seite 12

Safety instructions
After working
• The throttle should be closed before switching off the engine.
If the engine is equipped with a petrol shut-off valve then this
be closed after mowing has been completed.
• Do not leave the mower in closed areas after switching off -
allow it to cool off in the open air before storing away.
• Never keep the machine with petrol in the tank within a build-
ing in which gasoline vapours may possibly come into con-
tact with naked fl ames or sparks. Before leaving the mower
remove the spark plug lead and - if fi tted - the starting key.
• Lifting and carrying the mower for transport:
• Never attempt to lift the mower with the engine running - nor with
a hot engine - always remove the spark plug lead before lifting or
carrying.
• When folding the mower handlebars, detach starter rope
and make certain that the control cables are not snagged or
stretched when folding or unfolding.
• Always carry out the engine oil change with the fuel tank
empty and fi ller cap fi tted. The engine should be warmed
up prior to draining the oil to ensure all sludge deposits are
drained away with the oil.
Maintenance
• Regularly examine all fi xing bolts and nuts, particularly those
of the cutter bar, for tightness.
• Maintenance and cleaning of the equipment as well as remov-
ing the protection device may only be performed with the
engine stopped and the spark plug lead and - if available - the
starting key, removed.
Assembly
Fixing of handle A B
ATTENTION! Take care that theswitch cable does not become
caught and crused when folding the handle frame.
Starter cord assembly C G
1. Lift and hold operator presence bail arm
2. Pull the starter rope slowly to the holding bracket.
3. Twist the cord through the holder
Always remove the starter cord from the holder before
folding the mower handles.
G
(1).
.
C
Note information on the chassis before cleaning and oil change!
• Make certain that all nuts, pins and screws are fi rmly tight-
ened and that the unit is in a safe operating condition.
• In order to avoid the risk of fi re keep the engine, exhaust,
battery box and the area around the fuel tank free of grass,
leaves or oil.
• If the equipment must be tilted for maintenance work then the
fuel must be completely drained from the tank beforehand.
• Clean the equipment after each use with a hand-brush - not
with water and do not hose down with a high pressure hose
in particular. Make certain to keep the engine cooling fi ns and
engine cooling air intake clean and free from debris.
• Do not place the equipment in damp areas, near naked
fl ames or where a spark might ignite petrol vapour.
• If the fuel tank is to be emptied then this should be done out-
doors. Make sure that no fuel is spilled.
• For safety reasons replace worn out or damaged parts.
• NOTE! Always have blades replaced or sharpened by a
WOLF-Garten Service Centre, as a blade balance test must
be performed in accordance with safety regulations and the
blade retaining bolt must be tightened to a specifi ed torque.
• Wear suitable work gloves when carrying out the above work,
especially when handling the blade.
Mount grass catcher D E F
See illustrations.
13