Stopping Engine - Solo 433 Originalbetriebsanleitung Und Gebrauchsanweisung

Adjust choke (1) as follows:
When the engine is cold:
With the choke lever (1) up ( ) start the engine
by pulling the starter handle up in a straight line
several times until the engine is briefly audible
(ignition).
Then immediately move the choke lever (1)
down. Continue to start until the engine runs
evenly.
When the engine is warm:
With the choke lever down start the engine by
pulling the starter handle up in a straight line
several times until the engine runs evenly.
We recommend the following procedure if the
engine is flooded and it is difficult to start the
engine:
 Remove the spark plug and dry fuel mixture
from the electrodes.
 Move the throttle lever up to full throttle. Pull the
starter handle several times (with removed
spark plug) to clear the combustion chamber.
 Move the throttle lever down to idling position,
refit the spark plug, the plug cap and the plug
cover.
After the engine runs adjust the throttle lever (8) to
obtain the required engine speed. Use full throttle
if the sprayer is set for high spray pressure. If
lower pressures are required, only use ¾ throttle.
This will save fuel. Then turn the pressure
regulator (10) to set the required pressure which is
indicated by the pressure gauge (16) fitted to the
operating handle (15).
Also note the hints provided in section 12.2
"Pressure Regulation".
Caution:
void clutch slippage. If needed increase the engine
speed with the throttle lever after setting the spray
pressure with the pressure regulator.
The following hints serve to extend the service life
of the starter rope and the starter mechanism:
 Always pull up the starter rope in a straight line.
 Do not let the rope rub against the edge of the
rope eyelet to prevent fraying.
 Do not pull out the rope over its full length to
prevent breakage.
 Guide the starter handle to its initial position
rather then letting the handle slam against the
starter housing.
A damaged starter rope can be replaced by a
service specialist.
Starting / Stopping the engine

10.3 Stopping engine:

Fig. 9
(schematic diagram / depending on the version)
Press stop button (9) until the engine stops.
ENGLISH 13