Technical Data; Installation - Electrolux ESF65040 Benutzerinformation

36 electrolux

Technical data

Dimensions
Electrical connection - Voltage -
Overall power - Fuse
Water supply pressure
Capacity

Installation

Fitting under a counter
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Put the appliance adjacent to a water tap and
a water drain. Remove the appliance work-
top to install it under a sink unit or a kitchen
worktop. Make sure that the dimensions of
the recess agree with the given dimensions.
Do these steps to remove the appliance
worktop:
1. Remove the rear screws (1).
Width cm
Height cm
Depth cm
Information on the electrical connection is given on the rating plate
on the inner edge of the dishwasher door.
Minimum
Maximum
Place settings
2. Pull the worktop from the behind the ap-
3. Lift the worktop and move it from the front
4. Use the adjustable feet to adjust the level
5. Install the appliance under the kitchen
If a repair is necessary, the appliance must
be easily accessible for the engineer. Install
the appliance worktop to the appliance if you
want to use the dishwasher as a freestanding
appliance.
The plinth on freestanding appliance is not
adjustable.
Adjusting the level of the appliance
Make sure that the appliance is level to close
and seal the door correctly. If the level of the
appliance is correct, the door does not catch
on the sides of the cabinet. If the door does
not close correctly, loosen or tighten the ad-
justable feet until the appliance is level.
pliance (2).
slots (3).
of the appliance.
worktop. Make sure that there are no
kinks in the water hoses and that the wa-
ter hoses are not squashed.
60
85
61
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
12