Connecting The Power Cord (1) - Pioneer AVIC-F30BT Installationsanleitung

Section
02 Connecting the system

Connecting the power cord (1)

Note
Depending on the types of vehicles, the
function of *2 and *4 may be different. In this
case, be sure to connect *1 to *4 and *3 to *2
as shown in the figure.
ISO connector
Note
In some vehicles, the ISO connector may be divided
into two. In this case, be sure to connect to both
connectors.
10
Engb
*2 *1
*4 *3
Yellow (*2)
Yellow (*1)
Back-up To terminal supplied with
(or accessory) power regardless of ignition
switch position.
Red (*3)
Red (*4)
To electric terminal controlled by
Accessory
ignition switch (12 V DC) ON/OFF.
(or back-up)
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Notes
· When a subwoofer (*5) is connected to this
navigation system instead of a rear speaker, change
the rear output setting in the initial setting. (Refer to
Operation Manual.) The subwoofer output of this
navigation system is monaural.
· When using a subwoofer of 70 W (2 Ω), be sure to
connect with violet and violet/black leads of this
navigation system. Do not connect anything with
green and green/black leads.
Connect leads of the
same colour to each other.
Speaker leads
Front left 
White:
White/black: Front left 
Front right 
Grey:
Front right 
Grey/black:
Rear left  or Subwoofer  (*5)
Green:
Green/black: Rear left  or Subwoofer  (*5)
Rear right  or Subwoofer  (*5)
Violet:
Violet/black: Rear right  or Subwoofer  (*5)