Connecting The Power Cord (1) - Pioneer AVIC-F910BT Bedienungsanleitung

Section
03 Connecting the System

Connecting the power cord (1)

Note
Depending on the kind of vehicle, the function
of *3 and *5 may be different. In this case, be
sure to connect *2 to *5 and *4 to *3.
Cap (*1)
When not using this terminal,
do not remove the cap.
ISO connector
Yellow/black
If the vehicle can send a mute signal to this terminal, the
mute function can be activated on this navigation system
when the terminal is connected to *8.
Note
In some vehicles, the ISO connector may be divided into two.
In this case, be sure to connect to both connectors.
10
Engb
*1
*3 *2
*5 *4
Yellow (*3)
Yellow (*2)
Back-up To terminal always supplied
(or accessory) with power regardless of
ignition switch position.
Red (*4)
Red (*5)
To electric terminal controlled by
Accessory
ignition switch (12 V DC) ON/OFF.
(or back-up)
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Notes
· When a subwoofer (*9) is connected to this
navigation system instead of a rear speaker, change
the rear output setting in the Initial Setting. (Refer to
"Operation Manual".) The subwoofer output of this
navigation system is monaural.
· When using a subwoofer of 70 W (2Ω), be sure to
connect with violet and violet/black leads of this
navigation system. Do not connect anything with
green and green/black leads.
Connect leads of the
same colour to each other.
Speaker leads
Front left 
White:
White/black: Front left 
Front right 
Grey:
Front right 
Grey/black:
Rear left  or Subwoofer  (*9)
Green:
Green/black: Rear left  or Subwoofer  (*9)
Rear right  or Subwoofer  (*9)
Violet:
Violet/black: Rear right  or Subwoofer  (*9)