Electrical Safety; Assembly And Adjustments - DeWalt D28415 Originalanweisungen

INTENDED USE
Your D28415 angle grinder has been designed for
professional grinding applications.
DO NOT use grinding wheels other than center
depressed wheels and flap-disc.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These heavy-duty angle grinders are professional
power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
Soft Start Feature
(D28415-QS only)
The soft start feature allows a slow speed build-up
to avoid an initial jerk when starting. This feature is
particularly useful when working in confined spaces.
Auto-balance Feature
The auto balance feature continuously adjusts the
balance to reduce the vibration of the machine when
it is running. This improves user comfort during the
operation and is particularly useful when using the
machine for long periods of time.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
2
size is 1 mm ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
Attaching the Side Handle (fi g. 5)
WARNING: Before using the tool,
check that the handle is tightened
securely.
For grinding, screw the side handle (e) tightly into
one of the holes (o) on either side of the gear case
(fig. D1).
For cutting, screw the side handle (e) tightly into the
top hole (p) or into one of the holes (o) on either side
of the gear case (fig. 5).
Mounting and Removing the Guard
(fi g. 2)
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
1. Place the angle grinder on a table, spindle up.
2. Release the clamping lock (f) and hold the
guard (d) over the tool as shown.
3. Align the lugs (g) with the notches (h).
EN GL IS H
33