TrekStor DataStation t-series Bedienungsanleitung Seite 10

2) Startup
EN
DataStation maxi
a)
• Connect the supplied power cable to the power supply, and connect the power supply to the "
• Only use the provided USB connection cable to connect the device to a USB port in your PC.
DataStation by briefly pressing the on/off switch
• Turn on the
DataStation pocket
b)
Use the provided USB Y-connection cable to connect the DataStation to your PC. Connect the mini-USB A-plug to the
DataStation and both USB A-plugs to the USB port of your PCs. Your operating system will immediately recognize the
DataStation and will add the DataStation as a "l
Note: If only one free USB connector is available on your PC or notebook, please proceed as follows:
1) Connect the USB plug (1) to the power supply with a USB charger
(e.g., TrekStor USB charger e.f., optionally available in the market)
or an active USB hub.
2) Next, connect the USB plug (2) to the data transmission on your
PC or notebook.
3) Connect the mini-USB plug (3) to the DataStation.
(3.5 inch)
. Hold down the on/off switch
)
(2.5 inch)
D " (or "l
ocAl isk
– 10 –
D ") under "m c
ocAl rive y omPuter
p " connection of the device.
oWer
to turn off the DataStation.
)
".