Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Permanent switching of USB 2.0 devices
In the default settings of the KVM switch, KVM data and the data of devices con-
nected to the »USB 2.0 Devices« interface are forwarded to the computer of the
active channel.
Enable USB pinning (see page 32) if you want to permanently switch the data of
devices connected to the »USB 2.0 Devices« interface to a defined channel. The per-
manent switching of these devices (see page 13) remains the same even when
switching the KVM channel.
Enabling permanent switching of USB 2.0 devices
How to permanently switch USB 2.0 devices to a channel:
1. To activate the setup mode, press
Hotkey+Backspace
If the hotkey delay is enabled, press and hold the key combination for seven
seconds.
2. Enter one of the following key combinations:
IMPORTANT:
Press
U1
Permanent switching of USB 2,0 devices to channel 1
U2
Permanent switching of USB 2,0 devices to channel 2
Permanent switching of USB 2,0 devices to channel 3
U3
U4
Permanent switching of USB 2,0 devices to channel 4
Permanent switching of USB 2,0 devices to channel 5
U5
Permanent switching of USB 2,0 devices to channel 6
U6
U7
Permanent switching of USB 2,0 devices to channel 7
Permanent switching of USB 2,0 devices to channel 8
U8
NOTE:
The LED
Active
Disabling the permanent switching of USB 2.0 devices
How to disable the permanent switching of USB 2.0 devices:
1. To activate the setup mode, press
Hotkey+Backspace
If the hotkey delay is enabled, press and hold the key combination for seven
seconds.
2. Press
and immediately
U
NOTE:
After disabling the permanent switching of USB 2.0 devices, the devices are
switched to the active KVM channel (see page 9).
(default:
Ctrl+Backspace
U
and immediately the
shows the switching status (see page 8).
(default:
Ctrl+Backspace
.
0
) at the same time.
number
of the desired channel.
) at the same time.
G&D DVIMUX8-USB · 13
Switching
Werbung
Kapitel
Inhaltsverzeichnis
