Installation - IKEA REALISTISK Anweisungen

ENGLISH

Installation

After unpacking the oven, make sure that
it has not been damaged during transport
and that the oven door closes properly. In
the event of problems, contact the dealer or
your nearest After-sales Service. To prevent
any damage, only remove the oven from
its polystyrene foam base at the time of
installation.
Preparing the housing unit
• Kitchen units in contact with the oven
must be heat resistant (min 90°C).
• Carry out all cabinet cutting work before
fitting the oven in the housing and
remove all wood chips and sawdust.
• After installation, the bottom of the oven
must no longer be accessible.
• For correct appliance operation, do
not obstruct the minimum gap between
the worktop and the upper edge of the
oven.
General recommendations
Before use
- Remove cardboard protection pieces,
protective film and adhesive labels from
accessories.
- Do not remove the rating plate situated
on the right side of the door frame.
- Remove the accessories from the oven
and heat it at 200° for about an hour
to eliminate the smell and fumes from
the insulating materials and protective
grease.
During use
- Do not place heavy objects on the door
as they could damage it.
- Do not cling to the door or hang
anything from the handle.
- Do not cover the inside of the oven with
aluminium foil.
- Never pour water into the inside of a
hot oven; this could damage the enamel
coating.
- Never drag pots or pans across the
bottom of the oven as this could damage
the enamel coating.
- Make sure that the electrical cables of
other appliances do not touch hot parts
of the oven or become trapped in the
door.
- Do not expose the oven to atmospheric
agents.
17