Automatically Search For Common Brands; Automatically Search For Codes For All Brands - Marmitek easy control 8 Betriebsanleitung

If your device (TV, satellite, etc.) does not respond, you can try another code for your
brand. If the device does not react to any of the codes, then try the method in paragraph
4.4, Manually searching for codes.

4.2 Automatically search for common brands

If your brand is listed here, you can search by brand (this is quicker than searching
manually or automatically)
Brand
Philips/Radiola/Aristona/Erres
Sony/Panasonic/JVC/Sharp Akai/Toshiba/Daewoo
Thomson/Brandt
Telefunken/Saba/Nordmende
Grundig/Blaupunkt
Nokia/ ITT
1. Turn the device you want to operate on.
2. Press SETUP (9) and keep this button pressed until one of the mode LEDs stays
lit. Release the SETUP button.
3. Press the Mode button (2) for the device you want to operate. The LED will
flash once.
4. Enter the code matching your brand, point the EasyControl 8 remote control at
the device and press Prog+ (6) once. Keep the remote control pointed at the
device until it changes channel. (The remote control transmits one infrared
signal per second. Wait until the device reacts.) When the device reacts, press
-/-- (12) to confirm the code. If you accidentally miss the code, you can stop the
search by pressing Prog- (6) and go back to the correct code by repeatedly
pressing this button. Press -/-- (12) to confirm the code.
Note: If certain functions of your device do not work, try the next code for your brand.
The search function will begin after the last confirmed code. If that was 030, the search
function will begin at 031 and will continue until the last possible code.
4.3 Automatically search for all brands
When you are looking for an unknown code, you can automatically search through all the
codes (AutoSearch).
Note: Because you can assign every device (DVD, satellite) to the VCR, CBL, DVD, AUDIO
and ASAT and DSAT buttons, you first have to enter a 3-digit code for the type of device
that you want to operate (see the code book). For example: If you want to program a
satellite on the DVD button, you first have to enter a RANDOM satellite code from the
code book and follow the following steps:
1. Turn the device you want to operate on.
2. Press SETUP (9) and keep this button pressed until one of the mode LEDs stays
lit. Release the SETUP button.
EASYCONTROL 8
CODE
1
2
3
4
5
6
9