Foreword - Marmitek easy control 8 Betriebsanleitung

1. Foreword

You can operate up to 8 devices with the EasyControl 8 remote control: TV, VCR (video
recorder), CBL (decoder, set top box), DVD, Audio (CD, amplifier), ASAT (analogue satellite
receiver) and DSAT (digital satellite receiver), and your Home Control modules (button
with the yellow house).
The remote control contains a large number of pre-programmed codes. These codes are
suitable for almost all currently available devices and must be programmed once before
use. There are various ways to do this:
a. By manually entering one of the codes for the relevant brand that can be
found in the accompanying code book (see figure 4.1).
b. By using Auto Search to find common brands (see figure 4.2).
c. By using Auto Search for all brands (see figure 4.3).
d. By manually checking all the codes (see figure 4.4).
Home Control: control all electrical appliances with one remote control
The Marmitek Easycontrol 8 has two transmitters: an infrared (IR) transmitter and a radio
frequency (RF) transmitter. This allows you to operate practically anything electrical. You
can operate your TV, video etc. with the infrared (IR) technology. The X-10 radio frequency
(RF) technology makes it possible to operate lights and appliances from anywhere in the
home. There are countless possible home applications for the Marmitek X-10.
Here are some examples of the uses of the Marmitek X-10 Home Control:
• Dim the lights and switch them on and off while watching TV.
• Turn the coffee machine on from your bedroom when you wake up in the morning.
• Turn your lights on at night to scare off intruders when you hear noises.
• Switch on your electric blanket before the movie ends, so you can enjoy a warm bed
once the movie is finished.
• Switch everything off with a single press of a button when you go to bed.
Read more about the Marmitek Home Control Modules and Control Anywhere in the grey
section.
Marmitek Home Control Modules
If you want to control your lights and appliances you will also need, besides the EasyControl
8, a Marmitek X-10 Home Control Module. This can be plugged into any electrical socket.
No hassle with extra cables: extra wiring is not necessary because the connected device is
operated via your EasyControl 8 module (with RF signals). Use the Marmitek Home Control
TM13 module (available separately) and connect your table lamp or other electrical appli-
ance. Switch on/off: control everything with the EasyControl 8. The Home Control TM13
module converts the RF signals of the EasyControl 8 into an X-10 signal that is then trans-
ferred via the mains. All the other X-10 modules that are connected to your
mains, are also operated through the EasyControl 8 module. Read more
about this subject on the Marmitek web site www.marmitek.com
Article numbers: 09666 (G), for use in The Netherlands and Germany),
09674 (F) for use in Belgium and France, 09675 (U) for use in England]
4 MARMITEK