AEG dvd 4611 hc Bedienungsanleitung Seite 54

Starting up Themen
Fig. 2/21
Fig. 2/17
Fig. 2/15
54
Stereo
Connect both Audio cables for the right and the left speakers to your playback
device or your amplifi er.
1. Plug the Audio jacks into the sockets on the back of the player (L1/R1 or
L2/R2).
2. Plug the Audio jacks into the corresponding sockets on your playback
device or your amplifi er.
5.1-Audio signal (Connecting the Loudspeakers Supplied)
If you would like to achieve a replay of almost original quality you should use
an Audio output by means of a 5.1-Audio signal.
Here you should use the 6 loudspeakers supplied. Four of these speakers are
placed in the four corners of the room. One speaker is positioned close to the
playback device. The sixth speaker serves the output of very low tones. With
this arrangement of speakers a very natural stereophonic sound is achieved.
Connect the SPEAKERS OUT connection on the rear of the DVD player to the
corresponding connections on the rear of the individual loudspeakers.
Proceed as follows:
1. Connect the end of the cable to the socket on the rear of the device.
Please ensure the correct confi guration:
- (1) Connection for Subwoofer: Bass
- (2) Connection for Center speaker
- (3) Speaker rear right
- (4) Speaker rear left
- (5) Speaker front right
- (6) Speaker front left
2. Connect the other end of the cable to the corresponding sockets of your
playback device or amplifi er.
Digital
Connect the Coaxial cable for transmission of digital Audio signals to your
playback device or your amplifi er.
1. Plug the Audio jack into the socket on the back of the player.
2. Plug the Audio jack into the corresponding socket on your playback device
or your amplifi er.