Yamaha RX-V863 Bedienungsanleitung Seite 110

Advanced setup
See page 107 for the operation of the advanced setup.
■ Remote control AMP ID
Use this feature to set the AMP ID of this unit for remote
control recognition. This feature is useful when you
operate this unit and the other Yamaha receivers/
amplifiers in the same room separately.
Choices: ID1, ID2
• Select "ID1" when the remote control AMP ID code is
set to "2201".
• Select "ID2" when the remote control AMP ID code is
set to "2202".
Setting remote control AMP ID codes
You need to set the remote control AMP ID code for the
remote control.
Set the operation mode selector to F AMP or
1
F SOURCE.
Press and hold C LEARN for about 3
2
seconds using a ballpoint pen or similar
object and then press 9 l / h repeatedly
until "L;AMP" appears in the display window
( 6 ) on the remote control.
LEARN
Notes
• Be sure to press and hold C LEARN for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 1.
Press 9 ENTER.
3
The four-digit code set for the selected input area
appears in the display window ( 6 ) on the remote
control.
108
En
4
REMOTE AMP
Remote control AMP ID codes
Select one of the following codes to set the remote control
AMP ID code for the input area you want to use.
AMP ID code
(remote control
(initial setting)
5
PRESET/CH
ENTER
A/B/C/D/E
6
Press the numeric buttons ( A ) to enter the
four-digit remote control code for the input
area you want to use.
LIVE/CLUB
CLASSICAL ENTERTAIN
1 2
STEREO ENHANCER SUR. DECODE
5 6
MULTI CH IN
9 0
Function
setting)
2201 To operate this unit using the
default code.
2202 To operate this unit using an
alternative code.
Press 9 ENTER to set the number.
"OK" appears in the display window ( 6 ) if setting
was successful.
"NG" appears in the display window ( 6 ) if the
setting was unsuccessful. In this case, start over from
step 1.
Press C LEARN again to exit from the setup
mode.
LEARN
MOVIE
3 4
PARAMETER
7 8
Remote
control AMP
ID
ID1
(initial setting)
ID2