Adding Salt; Daily Use - ZANKER KDT 10032FK Benutzerinformation

supply. If not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance. Do
not use detergent and do not load the baskets.

Adding salt

Before first use put one litre of water in the salt container.
Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent it, after you fill the
salt container, start a programme.
Adding rinse aid
The rinse aid helps to dry dishes without streaks ans stains. It is automatically released during the hot rinse phase.
• Fill the rinse aid dispenser until the rinse aid dispenser reaches the marking "MAX".
• Remove the spilled rinse aid with an absorbent cloth to prevent too much foam.
• Fill the rinse aid dispenser when the indicator (A) becomes clear.

Daily use

1. Open the water tap.
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in programme selection
mode.
• If the salt indicator is on, fill the salt container.
When you start a programme, the appliance can take up
to 5 minutes to recharge the resin in the water softener.
It seems that the appliance is not working. The washing
phase starts only after this procedure is completed. The
procedure will be repeated periodically.
A
• If the rinse aid indicator is on, fill the rinse aid
dispenser.
3. Load the baskets.
4. Add the detergent. If you use multi-tablets, activate
the option Multitab.
5. Set and start the correct programme for the type of
load and the degree of soil.
9