Internal Cleaning; Troubleshooting - ZANKER KDT 10032FK Benutzerinformation

Internal cleaning

• Carefully clean the appliance, including the rubber
gasket of the door, with a soft moist cloth.
• If you regularly use short duration programmes,
these can leave deposits of grease and limescale

Troubleshooting

If the appliance does not start or it stops during
operation. Before you contact an Authorised Service
Centre, check if you can solve the problem by yourself
with the help of the information in the table.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with wa-
ter.
The display shows
The appliance does not drain the
water.
The display shows
The anti-flood device is on.
The display shows
Once you have checked the appliance, deactivate and
activate the appliance. If the problem occurs again,
contact an Authorised Service Centre.
The washing and drying results are not satisfactory
Problem
There are whitish streaks or bluish lay-
ers on glasses and dishes.
14
• Make sure that the mains plug is connected to the mains socket.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the end of the count-
down.
• The appliance has started the procedure to recharge the resin inside the
water softener. The duration of the procedure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low. For this
information, contact your local water authority.
.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
.
• Close the water tap and contact an Authorised Service Centre.
.
• The release quantity of rinse aid is too much. Adjust the rinse aid selec-
tor to a lower position.
• The quantity of detergent is too much.
inside the appliance. To prevent this, we
recommend to run long duration programmes at
least 2 times per month.
With some problems, the display shows an alarm
code.
Possible solution
For alarm codes not described in the table, contact an
Authorised Service Centre.
Possible solution