Before Using The Appliance; Preparation Of Ice Cream - Unold Polar Bedienungsanleitung

18. During operation, the ventilation slots of the
compressor housing as well as of the motor
block must be free and uncovered.
19. Do not use the appliance with accessories of
other machines or brands.
20. Do not use any sharp objects to take out
the ice cream. Only use plastic or wooden
spoons or spatulas.
the manufacturer will not be liable in the event of incorrect assembly, improper or incorrect use or if
repairs are carried out by unauthorized third parties.

Before using the aPPliance

1. Before using the appliance for the first time,
wash the removable parts except motor
block (1) and compressor housing (5) in
warm soapy water.

PreParation of ice cream

Control lamp
KÜHLEN/Cooling
ON/OFF
START/STOP
1. Prepare the ingredients according to the
respective recipe. If the ingredients must be
cooked before, do this the day before as the
ice cream mass must be cooled down before
filling it into the ice machine.
2. Mash fruits only directly before preparing
the ice cream, add fruit pieces only at the
end of the freezing procedure.
3. Cool the prepared ice mass resp. the
ingredients in
temperature of approx. 6-8°C.
4. Fill the cooled ingredients into the ice cream
bowl (4). Do not exceed the maximum filling
quantity of ¾ of the ice cream bowl volume,
as the ice cream will get more volume during
freezing.
5. Use alcohol only in small quantities as it
prolongs the freezing time.
6. Place the mixer (3) in the middle of the ice
cream bowl (4).
7. Place the filled ice cream bowl (4) into the
recess of the compressor housing (5).
16
the refrigerator to
21. Check the plug and power cord regularly for
wear and damage. In case of a fault, please
send the appliance for inspection/repair
to our after sales service (address see last
page). Inadequate repair may constitute a
risk for the user and result in the loss of
guarantee.
2. Wipe the motor block and the compressor
housing with a damp cloth.
3. Place the appliance on a flat and dry
surface.
LCD-Display
ZEITWAHL/Time selection
10/20/30/40/50/60 Min.
8. Place the transparent lid (2) on top and turn
it clockwise (bayonet lock). The opening for
refill of ingredients must be at the left side.
9. Place the motor block (1) on the transparent
lid (2) and make sure, that the drixe axle
(3) fits into the opening of the mixer and
that the power contact with the compressor
housing (5) is established.
10. Put the plug into a power socket and press
a the button ON/OFF to start the appliance.
The display shows „60:00" an. The
appliance is ready for operation.
11. Select the desired freezing time by repeated
pressing of the button ZEITWAHL/Time
select in steps of 10 minutes (10, 20, 30,
40, 50 or 60 minutes).
12. Press the
appliance starts mixing. The green control
light is turning on.
13. Approx. 2 minutes later the freezing is turned
on and the red control light turns on.
Control lamp
RÜHREN/Mixing
START/STOP button. The