Before First Use; Preparing The Tool For Use; Maintenance And Cleaning; Service - Parkside PHP 500 B2 Bedienungs- Und Sicherheitshinweise

Operation / Maintenance and Cleaning / Service
operation
Q

Before first use

Q
Preparing the glue site:
D o not use inflammable solvents to clean the
glue site.
T he ambient temperature and temperature of
the materials to be glued must be not less than
+ 5° C and not warmer than + 50° C.
T he glue sites must be clean, dry and free of
grease.
S mooth surfaces should be roughened before
gluing.
W arm any materials that are prone to cool
down quickly (e.g. steel) to improve the bond
with the glue.
S crew on the appropriate nozzle
the wire stand .
6

Preparing the tool for use

Q
Working with the mains lead connected:
1. Connect the mains lead
connection (see Fig. F).
10
Insert the mains plug into the mains socket.
2. Fold forward the wire stand
Stand the device up.
3. Push a glue stick into the feed channel
4. Let the device heat up for about 5 minutes.
The device is now ready for use.
Cordless working:
1. Connect the mains lead
connection .
3
Insert the mains plug into the mains socket.
2. Place the glue gun into the charger
3. Push a glue stick into the feed channel
4. Let the device heat up for about 5 minutes.
The device is now ready for use.
5. Repeat the heating-up procedure if the feed
switch becomes stiff or the outcoming glue
becomes viscous.
Gluing:
P ress the feed clamp
glue as required for your work.
26 GB
and fit
8
to the glue gun
11
.
6
.
1
to the charger
11
.
4
.
1
to regulate the flow of
5
1. Apply the glue in individual dots. Apply in zig-
zags on flexible materials such as fabrics.
2. Immediately after applying the glue, press the
two materials together for about 30 seconds. The
glued joint can be loaded after about 5 minutes.
3. When you take a break from work, set the
glue gun down on the wire stand
charger .
4
4. Remove any glue residue with a sharp knife
after cooling. Glued joints can be loosened
again by applying heat.
Switching off the device:
P ull the mains lead out of the mains socket.
Changing the nozzle:
Wear protective gloves.
H eat up the device for about 5 minutes.
Change the nozzle
d ANGeR oF BURNS!
Touch the nozzle
8
The nozzle tip is hot!
Note: Hold item upright, tip up, to prevent glue
from flowing out.

Maintenance and Cleaning

Q
The glue gun is maintenance-free.
W ARNING! Pull the mains lead out of the
mains socket before you clean the tool.
A lways keep the device clean and dry.
D o not allow any liquids to enter the tool. Use
a soft cloth to clean the housing. Never use
petrol, solvents or cleaning agents that might
attack plastic.

Service

Q
repaired only by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
lead needs to be replaced, always have
or in the
6
when it is hot.
8
only by the heat shield
Have your device
If the plug or mains
.
9