Dmx Mode - EuroLite LED IP T1000 HCL Bedienungsanleitung

DMX Mode

The device has six different DMX channel modes. The Control Board allows you, as described below, to
assign the DMX channel mode.
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED IP T1000 HCL 9x12W will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each LED IP T1000 HCL
9x12W correctly and independently from any other fixture on the DMX-chain. If several LED IP T1000 HCL
9x12W are addressed similarly, they will work synchronically.
If you set, for example in the 12 channel mode, the address to channel 13, the device will use the channel 13
to 24 for control.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
data received at the DMX-input, the dot behind the desired starting address will flash. If there is no data
received, the dot will not flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Addressing
Press the MENU button until the display shows ADDR.
Press the ENTER button and the display shows: 001.
Set the desired address via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to exit the DMX Mode
DMX Channel Selection: Choosing a DMX Channel Mode
After having set the desired address and pressed ENTER, you can now choose a DMX Channel Mode (4
CH, 5 CH, 6 CH, 7 CH, 9 CH or 12 CH).
Press the MENU button until the display shows SET.
Press the ENTER button and the display shows: 4 CH, 5 CH, 6 CH, 7 CH, 9 CH or 12 CH.
Set the desired DMX channel mode via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to exit the DMX Mode
Please see the following DMX protocol graphic for the respective channel values.
32/39 00095253.DOC, Version 1.0