Mounting Instructions - Klauke EPG-ULTRA-ID Bedienungsanleitung

Instruction manual EPG-ULTRA-ID
EKM 60 ID-L
4.2 Explanation of the application range
The crimping range is Cu10/Al50 mm² to 240 mm² for copper and aluminium cable lugs and connectors.
If different conducting materials have to be crimped, please contact the manufacturer.
Attention
Do not crimp on live cables or conductors.
The hand held tool is not supposed to be restrained in a vise. It is not allowed to use the tool in a stationary applica-
tion.
The tool is not designed for continued crimping operations. After a sequence of approximately 30-40 completed
crimps you have to make a break of 15 min. to give the tool time to cool down.
Attention
Too intensive use can cause heat damages for the tool
Attention
During the operation of electric engines sparks can occur which might ignite highly in ammable or explosi-
ve liquids and materials.
Attention
Electric-hydraulic crimping tools should not be operated in pouring rain or under water.

4.3 Mounting instructions

Copper R- and L-series connectors as well as connectors for  ne stranded cables in the range of 10 to 185
mm² are crimped once and 240 mm² are crimped twice. Also aluminium cable lugs and connectors in the range of 50
to 185 mm² are crimped once and 240 mm² twice.
A fault will be noti ed by optical (red LED) and accustical signals as indicated in table 1. If the red LED indicates
3 times and simultaneously 3 accustic signals occure the crimp is faulty. In this case the crimp must be repeated.
Please read the assembly instructions in our general catalogue.
HE.14820_C © 04/2013
l
Glomar AG Seestrasse 11
l l
CH-9326 Horn T +41 71 841 70 70
l
www.glomar.ch
6
GB
31