Memory; Displaying Stored Results - Medisana BU 575 CONNECT Gebrauchsanweisung

GB
4 Operating / 5 Memory
The blood pressure indicator
on the WHO blood pressure classification. If the unit has detected an irregular heart-
beat, the arrhythmia display
7. The readings are automatically saved in the selected memory (
a guest mode measuement has been finished (see chapter 4.2 Setting up the user
memory). Up to 180 measured values with date and time can be stored in each me-
mory.
8.
The measurement results will automatically be transferred via Bluetooth to receive-
ready devices. During this process, the Bluetooth-symbol
was successful, the Bluetooth-symbol
play. If the transfer was not successful, "Err" will appear.
9. The unit switches off automatically after approx. 1 minute if no buttons are pressed.
The unit may also be switched off using the START/STOP button
4.5 Transfer via Bluetooth to VitaDock online resp. VitaDock app
The MEDISANA Upper arm blood pressure monitor with travel alarm clock BU
575 connect offers the possibility to transfer your measured values via Bluetooth to
the VitaDock online portal resp. to the VitaDock app. These VitaDock applications
allow the evaluation, storage and synchronisation of your data between multiple iOS-
and Android-devices to have access to it anytime and anywhere. You may share your
results with your friends or your doctor. Therefore you need a free user account, which
you can create on the website www.vitadock.com. For Android or iOS mobile devices,
you may download the respective apps. You will find a detailed instruction for how to
install and use the software on the mentioned website. After each blood pressure
measurement an automatic transfer will be initiated by the device - Bluetooth therefore
should be activated and configured on the receiving device(s). If you want to transfer
the stored values from your BU 575 connect manually, please follow these steps:
Press and hold START/STOP-button
1.
transfer mode.
2. The Bluetooth-symbol
3. If the transfer was successful, the Bluetooth-symbol
"OK" in the display. If the transfer was not successful, "Err" will appear.

5 Memory

5.1 Displaying stored results

You can store up to 180 readings (blood pressure and pulse rate with the time and
date) in either one of the two memories in your blood pressure monitor. The measured
values are stored automatically. Press the M-button
stored. The average values of the last 3 measurements of the respective user appear
on the display. Press the M-button
stored measurement. Repeatedly pressing the M-button
values measured previously. Press the
more actual stored results. The unit switches off automatically after approx. one minu-
te if no buttons are pressed. The memory recall mode may be exited at any time by
pressing the START/STOP button
values have been stored in the memory and a new value is saved.
26


®

flashes and the transfer begins.
flashes next to the relevant coloured bar depending
appears additionally.

will appear together with "OK" in the dis-
®
®

for 3 seconds, to enter the manual


again to display the values from the previously
SET / SNOOZE - button

. The oldest value is deleted if 180 measured
or

will flash. If the transfer

®
®

will appear together with
to call up the measured values

displays the respective

to browse to the
i
), except if
i
i
.
i
i