Operating; Device Handling In Clock / Alarm Mode; Device Handling In Bloodpressure Mode - Medisana BU 575 CONNECT Gebrauchsanweisung

GB
3 Getting started / 4 Operating
b) The bloodpressure mode
The bloodpressure mode is activated by placing the device in a flat / lying position, e.g.
on a table. In this mode the LC-display shows the latest measurement results of the
current user.

4 Operating

4.1 Device handling in clock / alarm mode

Depending on the toggle switch position of alarm toggle 1
alarm 1 and / or alarm 2 is activated or deactivated (if an alarm is activated, the related
symbol
alarm toggle (
Setting the date, time and alarms to learn how to adjust the alarm time) and then the
actual date and clock will be shown.
When the set alarm time of an activated alarm is reached (if an alarm is activated, the
related symbol
alarm symbol (
 
( or
During an alarm, you may also press the SET / SNOOZE - button
alarm and activate it again 5 minutes later. In this case, the symbol "
the display. The snooze function may be used 6 times in sequence. If you press the
SET / SNOOZE - button

4.2 Device handling in bloodpressure mode

Setting up the user memory
The MEDISANA Upper arm blood pressure monitor with travel alarm clock BU
575 connect gives you the opportunity to assign readings to one of two user memories,
each of which provides 180 memory slots. Press and hold the M-button
seconds, until the symbol for User 1

you can switch User 1 and User 2 or Guest
of the reading will not be saved.
Press the SET / SNOOZE - button
24
resp. is displayed). If an alarm is activated by moving the respective
 
or ) to the left, the alarm time will shorty flash (check chapter 3.3
resp. is displayed), an acoustic alarm is emitted and the related
or ) flashes. To turn off the alarm, put the related alarm toggle
) to right position.

for a 7 time, the alarm will be toggled off constantly.
e. g. user 1:
Bloodpressure indicator: Green area
Systolic pressure: 120 mmHg
Diastolic pressure: 80 mmHg
Pulse rate: 80 beats / min.
th
appears in the display. By pressing M-button
. If you choose "Guest", the values

to confirm your selection.

resp. alarm toggle 2

to pause the
" appears in

for at least 3

i
i
i
i