Sd/Usb Operations - JVC KW-NT3 Bedienungsanleitung

SD/USB operations

This unit can play the MP3/WMA files stored in SD card/USB mass storage class device.
• All tracks in the SD card/USB device will be played repeatedly until you change the source.
• Make sure all important data has been backed up.
Inserting SD card
1
Detach the monitor panel.
2
Insert an SD card.
Push in the SD card until you hear a clicking sound.
3
Attach the monitor panel.
The source changes to "SD" and playback starts.
To eject the SD card
Detach the monitor panel, then push in the SD card
lightly.
Connecting USB device
You can connect a USB mass storage class device such as
a USB memory, Digital Audio Player, etc. to the unit.
• You cannot connect a computer or portable HDD to
the USB (
• When connecting a USB device, refer also to its
instructions.
Monitor panel
The source changes to "USB" and playback starts.
Caution:
• Avoid using the USB device if it might hinder your
safety driving.
• Do not start the car engine if a USB device is
connected.
• Do not pull out and attach the USB device
repeatedly while "File check" is shown on the
screen.
• Disconnect a USB device while playback is paused
or another source is selected.
• Electrostatic shock at connecting a USB device
may cause abnormal playback of the device. In
this case, disconnect the USB device then reset it
and detach the monitor panel (then attach it).
• Do not leave a USB device in the car, expose to
direct sunlight, or high temperature to avoid
deformation or cause damages to the device.
• For more details about USB operations,
☞ page 70.
57
) terminal of the unit.
USB cable (not supplied)