Setting Up Control Unit And Analyser Box Measurement System; Setting Up Bus Address; Selecting Instruments; Setting Language - testo 350 S Kurzanleitung

32

5. Setting up Control Unit and analyser box measurement system

5. Setting up Control Unit and analyser box measurement system

5.1. Setting up bus address

· Bus connection is set up for one analyser box.
· Measurement menu is activated.
Every instrument has a default bus address which makes it easy to identify. The bus
address consists of a two-digit number which is assigned as follows:
· Control Unit
· Analyser box
All bus ID addresses have to be different.
If the bus address is the same, it has to be changed!
Service
2 Select
3 Select digit and the value takes effect if
If high numbers are selected, it can take a while for the analyser box to be recognised
when first switched on.
4 The bus address applies once

5.2 Selecting instruments

· Measurement menu is activated.
1 Open system configuration with
- The system configuration with the Control Unit and all connected components
(logger, analyser box, analog output box, powerbox) is shown.
2 Select instrument and confirm with
- The reading display of the selected instrument appears.
5.3 Setting the language
· Control Unit is selected.
· Measurement menu is activated.
1 Open main menu.
Service
2 Select
- The selected language setting is displayed.
3 Select language and confirm with
5.4 Setting the date/time
· Control Unit is selected.
· Measurement menu is activated.
Device
1 Select
2 Select date or time using
3 Activate setting mode using
4 Select digit and the value applies once
5 The date/time comes into effect once
If a measuring program is activated, the date and time entries are locked. The message
Meas. p p rogram a a ctive
Select digits
in the date
line
Always 01 ex factory
10 to 20 ex factory
Bus a a ddress
–> .
is pressed.
Finish
is activated.
.
.
Sprache Lang.
–> or
.
Change d d ate
–> .
or .
Edit
.
is activated.
End
appears.
.
is activated.