Melitta CAFFEO SOLO & perfect milk Bedienungsanleitung Seite 86

Fault
The brewing unit
can no longer be
reinserted after
removal.
The symbols for
cleaning and
stand-by flash
alternately.
Continuous flashing
of all buttons
Please contact the Melitta
solve the problem: +49 571/ 86 1900.
84
cause
The brewing unit is not
properly locked.
The actuator is not in the
proper position.
The brewing unit is
missing or is not properly
inserted.
The brewing chamber is
overfilled.
System error
hotline, if the above mentioned solutions do not help to
®
Measure
Check whether the handle
for locking the brewing unit is
correctly engaged.
Switch the appliance OFF and
ON again, then simultaneously
press the button for coffee
dispensing and steam
dispensing for longer than
2 seconds. The actuator moves
into position. Then reinsert the
brewing unit and make sure it
is correctly locked into place.
Insert the brewing unit properly.
Switch off the appliance and
switch it on again via the ON/
OFF button (repeat if
necessary) until standby mode
is displayed
Switch off the appliance and
switch it on again via the ON/
OFF button ; if this does
not solve the problem send
the appliance to the service
department.