Cutters Edge CE2165RS Betrieb Und Wartung Seite 14

13 /
CUTTERS EDGE FIRE RESCUE SAWS
REMOVAL AND REINSTALLATION
OF THE GUIDE BAR AND CHAIN
REMOVE CLUTCH COVER
Using the scrench tool loosen the two clutch cover
bar mount nuts Shown in Fig. 4.
Remove Chain and Guide Bar from the saw.
TO REINSTALL CHAIN AND GUIDE BAR
To mount the guide bar, slide the guide bar onto
the two bar mount studs. See Fig. 5.
To install the chain, align the chain so that the
cutters are pointing toward the tip of the guide bar
as they lay on the top of the bar. Slip the chain onto
the clutch sprocket rim (Fig. 5). Then slip the chain
into the groove of the guide bar, again verifying that
the top cutters point toward the tip of the guide bar.
Pull the chain around the bar to be sure the drive
links are properly seated in the drive sprocket.
Mount Clutch Cover onto the two bar mount studs
(Fig.5) Using the scrench tool, turn the tensioning
adjustment screw to align the chain adjuster pin
with the hole in the guide bar. (Figs. 6 and 7).
When the adjuster pin is aligned with the hole in
the guide bar push the clutch cover to set it fully
against the saw. Install the two bar nuts finger tight.
Fig. 4. Clutch Cover Bar Mount Nuts
Fig. 5. Bar Mount Studs and Clutch Sprocket
Fig. 6. Tensioning Adjustment Screw
Fig. 7. Chain Adjustment Pin