Pipe Connection - ADURO 9-4 Bedienungsanleitung

_______________________________________________________________________________________________________________________________
Please note: Attachment / hanging of the stove
The stove is being delivered with wall fittings. The fittings must be properly fastened to the wall before the stove
can be mounted / hung up. You may consult your normal supplier of building materials about suitable attachment
materials such as screws / bolts / anchors for the stove / wall before the erection. ONLY USE FIXING MATERIALS,
WHICH CAN NOT MELT. The stove weighs 90 kg. If you have any doubts about the requirements, then please
consult your chimney sweep (who will inspect the stove). Please note: The lower edge of the stove must be
minimum 28 cm above the floor.
If the wood burning stove is to be placed close to flammable material, such as a wooden floor or carpet, it must be
placed on a non-flammable base. The floor plate should extend for at least 30 cm in front of the wood burning
stove, and 15 cm on each side.

2.2 Pipe connection

Aduro 9-4 leaves the factory with the flue outlet mounted on the top. If you require the flue outlet on the back,
remove the round circle from the rear cover at the upper rear of the stove and then exchange the exhaust
connector (located on the top outlet above the stove) with the cover plate (that covers the rear outlet). The top
outlet is finished with the plate that lies in the ash drawer. A flue pipe with an internal diameter of 150 mm should
be used for Aduro stoves.
2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney, the rear outlet should be used, or a curved flue pipe via the top
outlet. After measurement, a hole is made in the chimney in which the pipe sleeve is placed and fireplace mortar is
used to seal it in place. The stove is placed in position and the flue pipe is put in place. A thin gasket is placed
between the flue pipe and the pipe sleeve to seal the joints. The flue pipe should protrude 5–10 cm into the pipe
sleeve, but must not block the opening in the chimney (see the illustration below).
X
24