Pipe Connection - ADURO 9-2 Bedienungsanleitung

_______________________________________________________________________________________________________________________________
Please note: that the Aduro 9-2 must be installed on a floor with the adequate load-bearing capacity. If the existing
construction does not meet this requirement, appropriate adaptation measures must be taken (e.g. a load-
distributing plate).
If the wood burning stove is to be placed close to flammable material, such as a wooden floor or carpet, it must be
placed on a non-flammable base. The floor plate should extend for at least 30 cm in front of the wood burning
stove, and 15 cm on each side.

2.2 Pipe connection

Aduro 9-2 leaves the factory with the flue outlet mounted on the top. If you require the flue outlet on the back, you
0
need a 90 pipe instead of the straight one. This pipe can be rotated / angled so it fits the desired place at the wall.
The stove is equipped with an extra cover plate for the back, in which there are 3 marked pre-defined pipe
positions – angled 45
to place the pipe. The top outlet is finished with the plate that lies in the ash drawer. A flue pipe with an internal
diameter of 150 mm should be used for Aduro stoves.
2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney, a curved flue pipe should be used via the top outlet. After
measurement, a hole is made in the chimney in which the pipe sleeve is placed and fireplace mortar is used to seal
it in place. The stove is placed in position and the flue pipe is put in place. A thin gasket is placed between the flue
pipe and the pipe sleeve to seal the joints. The flue pipe should protrude 5–10 cm into the pipe sleeve, but must not
block the opening in the chimney (see the illustration below).
The wood burning stove can be connected to a chimney to which other heat sources are connected.
3.0 Lighting a fire in the wood burning stove
3.1 Important safety information

The wood burning stove will become warm during use and therefore it should be treated with all necessary
caution.
0
to both sides and one going straight back. Please simply remove the plate where you wish
X
22