Cleaning And Maintenance; Danger To Life - Futurelight PHS-750E Bedienungsanleitung

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) Mechanically moved parts like axles, eyes and others must not show any traces of wearing (e.g. material
abrading or damages) and must not rotate with unbalances.
4) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
The lens has to be replaced when it is obviously damaged,
so that its function is impaired, e. g. due to cracks or deep scratches!
The objective lens will require weekly cleaning as smoke-fluid tends to building up residues, reducing the
light-output very quickly. The cooling-fans should be cleaned monthly.
The PHS-750E is equipped with two dust protection filters inside the projector head. These must be cleaned
in six month intervals in order to guarantee perfect air circulation.
Procedure:
Step 1: Unscrew the fixation screws of the housing cover.
Step 2: Remove the housing cover.
Step 3: Remove the dust protection filters and clean them.
Step 4: Replace the dust protection filters in the housing and tighten the fixation screws.
Step 5: Replace the housing cover and tighten the fixation screws.
The gobos may be cleaned with a soft brush. The interior of the fixture should be cleaned at least annually
using a vacuum-cleaner or an air-jet.
The dichroic colour-filters, the gobo-wheel and the internal lenses should be cleaned monthly.
To ensure a proper function 002 Tc011.4Veaned 5.61(l)4p7st Mm-1()-o(e )12(B)3(n)-)-24 l
TJ0 12(o)--)-B1(cane)6(-)-(gob)-12(ef1(y.001(-)5w[ ( T)-1I(y.001(-)5wref5Bc80-5(en)-6u32)-8(-1(c-7( 00u32)-81(y22(y).)] T J0 2

DANGER TO LIFE!

Disconnect from mains before starting maintenance operation!
Do not operate this device with opened cover!
CAUTION!
y5nnually
62/120 00024321.DOC, Version 1.4