Operating Your Puro 4 - bianco PURO 4 Bedienungsanleitung

Operating your PURO 4

Energy Saving Mode
To switch on the device, place the mixing container (Fig.[1], page 2) on the locking mechanism (Fig.[10], page 2), this switches
the display on for 1 second and then automatically changes into the energy saving mode . In this mode the display is switched
1
off, only the On/Off button (Fig. [14] page 2) is lit red.
Standby Mode
You only have to press a button on the control panel or turn the jog-dial to switch the device from energy saving mode to
standby mode. Make sure that the mixing container is put on properly. In this mode the display shows „00:00" minutes and the
speed is set to "3" and all symbols on the control panel are lit and
Start of an Automatic Program
To start a program your PURO must be in standby mode. Now choose a program with the jog-dial, your choice of program is
on the display (Fig. [13], page 2). After the end of the program your PURO stops automatically.
On/Off switch
lit green. By pressing the On/Off button again the program is ended prematurely.
1
Power consumption in energy saving mode 0.339 Watt
EN
10