Tools Needed For The Assembly; Your Radio System - Carson CY Pro Chassis Betriebsanleitung

Tools Needed for the Assembly

Modelling knife 30 007 4053
GB
Philips screwdriver (small and big)
and hex-wrench
1,5/ 2 / 2,5 mm 30 007 4023
a. Your Radio System
Please read the instructions provided with your radio system before
using it.
The servos must be set at the centre position before installation. To set
the servos at a neutral position, turn on the transmitter and receiver.
Set the trim levers in the centre position and turn off the receiver, and
then the transmitter. The servos will be in proper neutral position for
installation.
Receiver antenna
Engine throttle
servo
18 CARSON CY Pro Chassis
Instant adhesive 30 005 3339
Hexagonal wrench 30 001 3118
(only for RTR version) ersion)
et
d
Batteries for receiver
Switch
Steering servo
Needle nose pliers 30 007 4034
Tweezers 30 007 4003
Transmitter Transmitter
Scissors 30 001 3305
Side cutter 30 007 4035