Tools Needed For The Assembly; Your 3 Channel Radio System - Carson STORMRACER extreme Betriebsanleitung

Tools Needed for the Assembly

GB
Modelling knife 50 007 4053
Philips screwdriver
(small and big)
1,5/ 2 / 2,5 mm 50 007 4023

Your 3 Channel Radio System

Please read the instructions provided with your radio system
before using it.
The servos must be set at the centre position before
installation. To set the servos at a neutral position, turn on
the transmitter and receiver. Set the trim levers in the centre
position and turn off the receiver, and then the transmitter. The
servos will be in proper neutral position for installation.
Receiver antenna
Engine
throttle
servo
6 CARSON Stormracer extreme 50 010 3013 RTR und 50 010 2001 ARR
Instant adhesive 50 005 3339
Hexagonal wrench 50 001 3118
Batteries for receiver
Switch
Steering servo
Needle nose pliers 50 007 4034
Tweezers 50 007 4003
(only for RTR version)
Transmitter
Scissors 50 001 3305
Side cutter 50 007 4035