Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation of the optional wireless receiver for WDMX-operation (FUTURELIGHT
WDR-G4)
Prior to installation, disconnect the device from the mains. Risk of electric shock!
Installation steps
1. Remove the wireless DMX receiver from the packaging. The module consists of a threaded rod
antenna, a wireless PCB and a connecting cable.
2. Remove the four screws from the control board on the front panel and carefully open the control
board cover, laying it face down. On the left side of the display board you will find two connectors for
the wireless DMX receiver.
3. First screw the rod antenna onto the antenna jack then place the antenna along the display board, in
the control board cover.
4. To attach the wireless PCB, loosen the three screws on the display board and remove them. Insert
the plug contacts of the wireless module into the socket on the display board and screw the three
screws on again. Insert the plug of the connecting cable into the designated socket.
5. Carefully replace the control board cover onto the control board and tighten the four screws on the
front panel.
A
C
CAUTION!
B
D
39/56
00088949.DOC, Version 1.1
Werbung
Inhaltsverzeichnis
